|
Post by bluegoalie on Apr 28, 2009 17:04:36 GMT -5
So I had a Vip622 and was able to receive Columbus locals here in Auburn with out a problem. My 622 hard drive went corrupt, so Dish sent a tech with a new 722. Well now after getting the OTA receiver installed into it, I now can not get my locals. Is it maybe a difference in the OTA receivers that would cause this? I'm just a little baffled. I have an Antennas Direct DB8 antenna with a CM 7777 pre amp. With my 622 i was getting 90-100 signal on some channels, and now nothing. Any suggestions?
|
|
|
Post by seanmc1114 on Apr 29, 2009 12:05:17 GMT -5
It's been a while since I've been with DISH, but I believe you have to do a scan for local channels on the receiver. Have you done that with the new one? Also, sometimes when I am adding to or rearranging my electronic components I will unplug my pre-amp and forget to plug it back in so that I lose my OTA signals. You might want to check that too.
|
|